GRAPHTEC FC8000 Series - How to Use Control Panel; Control Keys; Menu Keys; Indicator Lamp

2-16
2
-
2-17
6
How to Use Control Panel
This section explains the function of lamps and keys on the control panel.
USER 1 lamp USER 2 lamp [1] key
[2] key CROSS CUT
key
MENU lamp [MENU] key [STOP] key
[ORIGIN] key
[ENTER] key[CONDITION]
key
POSITION
(
▲
,
▼
,
◄
,
►
) key
[FAST] key[3] key [4] key
[COPY] key
Screen (LCD)
Control Keys
POSITION (
▲
,
▼
,
◄
,
►
) keys .......There are following functions depending on the operation.
Move the tool carriage and media. It will move specified distance (see
"Setting of Step Movement Distance"
P.3-4
) when it is pressed once,
and continuously move when it is pressed down. It will select the menu when
▲
,
▼
,
◄
, or
►
are displayed in the menu on the screen.
FAST ......................... The tool carriage or the media will move faster when it is pressed simultaneously with
POSITION key. It will work as a menu key when it is displaying "F" on the screen.
CROSS CUT ............. It will cut off the media that has finished cutting.
STOP ........................ Cutting operation will stop immediately when the [STOP] key is pressed while cutting.
You can reset the media by pressing the [STOP] key while cutting when the media has
shifted.
ORIGIN ..................... It will set the current position as an origin point.
The plotter is reset by pressing the [ENTER] key and the [ORIGIN] key simultaneously in
the first screen of the MENU mode (MENU screen).
COPY ........................ Copy of data in the buffer memory is output.
Menu Keys
MENU ....................... It will switch to the MENU mode. MENU lamp is lit in the MENU mode.
It will go into MENU mode if it is pressed once, and MENU mode will be turned off when it
is pressed again.
Different function are set in the MENU mode.
Data received while in the MENU mode will be stored in the data buffer.
CONDITION ............. It will display the screen to set the tool conditions.
1, 2, 3, 4 ................... Select the menu number displayed in the screen.
ENTER ...................... It will define the settings.
The plotter is reset by pressing the [ORIGIN] key and this key simultaneously in the first
screen of the MENU mode (MENU screen).
It will display current cutting area when the [ENTER] key is pressed in READY status.
Indicator Lamp
MENU lamp .............. Green lamp is lit while in MENU mode.
USER 1, 2 lamp ......... The lamp for selected user will lit.
The lamp is lit when the user priority is set to "Key, Controller". It will flash when it is set to
"Key only".