GRAPHTEC FC8000 Series - Enabling;Disabling 1;2 Pen Check (CHECK TOOL)

14-16
Enabling/Disabling 1/2 Pen Check (CHECK TOOL)
Supplement
This setting is maintained even if the power is
turned off.
This menu is not displayed on standard
equipment.
l
l
It is possible to disable the check if the tool is mounted on the pen
station at the media detection. It can be set back to enabled from
here too. Make sure to set the plotting pen to the pen station at the
power up when it is set to DISABLED.
Operation
CAUTION
Pen station is made for plotting pens only. Do not
mount the cutter pens.
1
Mount either the cutter plungers or the plotting pens and turn on
the power.
2
Press the [MENU] key in the default screen.
MENU screen is displayed.
3
Press the POSITION (
▼
) key (ADV).
POSITION
ADVANCE setting screen (1/3) is displayed.
4
Press the POSITION (
▼
) key.
POSITION
ADVANCE setting screen (2/3) is displayed.
Supplement
[4] is displayed only when there is a plotting pen
mounted on the pen station.
5
Press the [4] key (TOOL CHECK).
TOOL CHECK setting screen is displayed.
6
Press the [1] key (ENABLED) or the [2] key (DISABLED).
Supplement
It will return to TOOL setting screen without
changing the settings when you press the
POSITION (
◄
) key (CANCEL).
7
Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to ADVANCE setting screen (2/3).
8
Press the [MENU] key.
It will return to the default screen.