GRAPHTEC FC8000 Series - Manually Adjusting the Sensor Level (Threshold Value)

5-18
5-19
Supplement
It will return to ARMS setting screen (3/4) after
setting the sensor level to default when you press
the [2] key (DEFAULT).
6
Press the [1] key (SCAN).
Following message is displayed.
Supplement
The tool carriage will move faster when the [FAST]
key is pressed simultaneously with the POSITION
key.
7
Press the POSITION (
▲▼◄►
) key and move the tool carriage
to the area to start scanning of the registration mark.
POSITION
Registration mark scan area
Feed direction of media
Align the tool to this area
Y
X
Supplement
It will return to ARMS setting screen (3/4)
without adjustment when you press the [4] key
(CANCEL).
It may not scan correctly even after the
adjustment depending on the condition of the
media. See "Manual Position Adjust"
P.6-3
if the detection does not complete properly.
l
l
8
Confirm the position of the tool, and if it is OK, press the [ENTER]
key.
Registration mark is scanned, and sensor level is adjusted. It will return to
ARMS setting screen (3/4) once the adjustment is completed.
9
Press the [MENU] key.
It will return to default screen.
Manually Adjusting the Sensor Level (Threshold Value)
Scan level (threshold value between the media background color and registration mark) of the sensor scanning
the registration mark is set.
Sensor is adjusted to scan the registration mark written in black lines on white background. Adjust the scan
level of the sensor depending on the color and gloss of the media.
P.5-18
Adjusting the Sensor Level
Next page
Operation
1
Press the [MENU] key.
MENU screen is displayed.
2
Press the [2] key (ARMS).
ARMS SETTING screen (1/4) is displayed.