GRAPHTEC FC8000 Series - Changing CONDITION no; Setting to Default

3-6 3-7
Changing CONDITION No.
To change the CONDITION No., do following:
Operation
1
Press the [ENTER] key in READY status.
CONDITION No. selection screen is displayed.
Supplement
It will return to state when the power is turned on
when the [ORIGIN] key (RESET) is pressed.
See "Setting to Default"
P.3-6
.
2
Press the [1] key (No.1), the [2] key (No.2), the [3] key (No.3),
the [4] key (No.4), the [
▲
] key (No.5), the [
▼
] key (No.6), the [
◄
]
key (No.7), or the [
►
] key (No.8), while simultaneously pressing
the [ENTER] key.
POSITION
Setting will be set, and it will return to default screen.
Setting to Default
To move to the position as after the power was turned on, do following:
Operation
1
Press the [ENTER] key in READY status.
CONDITION No. selection screen is displayed.
2
Press the [ORIGIN] key, while simultaneously pressing the
[ENTER] key.
Initialization is performed, and SELECT screen is displayed.