GRAPHTEC FC8000 Series - Loupe (Adjusting the Position); Axis Alignment, Cut Area Positioning; Attaching the Loupe

14-2
14
-
14-3
Axis Alignment, Cut Area Positioning
The loupe (bombsight) is used to align points for adjustment during axis alignment operations, and to align
the corner points when specifying the plotting area. It indicates the current pen position, and is used for fine
adjustment The loupe is mounted in the tool holder.
Attaching the Loupe
Next page
Operation
Supplement
See "Attaching a Tool"
P.2-4
for how to
tighten the screws on the tool holder.
1
Loosen the tool holder screw.
Supplement
Use the same procedure to attach the pouncing
tool to the tool holder of the 2-pen model.
See "2 Pen Assignment (Switching the Tools)"
P.14-7
for 2-pen option.
Attach the loupe to the half cutting (backward)
side.
l
l
l
2
While pushing the tool holder in the upward direction, push the
loupe all the way into the holder until its flange contacts the
upper part of the tool holder.
Flange
Upper part of tool
holder
For half cutting
(backward)
For cutting out
(forward)
3
Make sure that the tool bracket is engaged on the loupe's
flange, and then tighten the screw.
Flange
Bracket to hold tool
1
Loupe (Adjusting the Position)