GRAPHTEC FC8000 Series - Setting Length of the Overcut

7-4
7-5
Setting Length of the Overcut
Set the length of overcut with tangential emulation.
Next page
Operation
1
Press the [CONDITION] key.
CONDITION setting screen (1/3) is displayed.
Supplement
It will return to default screen without changing the
settings when you press the [CONDITION] key.
2
Press the POSITION (
▲
) key.
POSITION
CONDITION setting screen (3/3) is displayed.
Supplement
It will return to the
CONDITION
screen
(3/3)
without changing the settings when you press the
POSITION (
◄
) key (CANCEL).
3
Press the [1] key (OVERCUT).
OVERCUT setting screen is displayed.
4
Press the [1] key CONDITION No.).
CONDITION No. selection screen is displayed.
5
Press the POSITION (
▲▼
) key and select the CONDITION No.
POSITION
6
Confirm the setting, and press the POSITION (
◄
) key
(PREVIOUS).
POSITION
CONDITION No. is selected and return to OVERCUT setting
screen.