GRAPHTEC FC8000 Series - 15-2 Main Specifications

15-6
15
-
15-7
2
Main Specifications
FC8000-60 FC8000-75 FC8000-100 FC8000-130 FC8000-160
CPU 32bit CPU
Configuration Grit-rolling plotter
Drive Digital servo
Max. Cut Area 50 m x 610 mm
(expanded mode)
50 m x 762 mm
(expanded mode)
50 m x 1067 mm
(expanded mode)
50 m x 1372 mm
(expanded mode)
50 m x 1626 mm
(expanded mode)
Guaranteed
precision
cutting
area
*1
15 m x 590 mm 15 m x 742 mm 10 m x 1047 mm
15 m x 894 mm
10 m x 1352 mm
15 m x 894 mm
10 m x 1606 mm
15 m x 894 mm
Mountable
media
width
Max: 730 mm
Min: 50 mm
Max: 901 mm
Min: 50 mm
Max: 1206 mm
Min: 50 mm
Max: 1511 mm
Min: 50 mm
Max: 1765 mm
Min: 50 mm
Max. cutting
speed
148.5 cm/s (45°direction)
Specifiable
speeds
1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 15, 20, 25, 30, 35, 40, 45, 50, 55, 60, 70, 80, 90, 100, 105 cm/s
Cutting
Pressure
48 steps, 0.196 to 5.88 N (20 to 600 gf)
Min. character
size
3 mm (0.125 in.) alphanumeric Helvetica med. Font
Mechanical
resolution
0.005 mm
Program
mable
resolution
GP-GL: 0.1/0.05/0.025/0.01 mm, HP-GL
*2
: 0.025 mm
Repeatable
accuracy
*1
Max. 0.1 mm/in unit of 2 m (excluding media shrinkage)
Number of
cutters/pens
1 (2 for 2-pen model
*3
)
Pen types Water-based fiber-tip, oil-based ballpoint, and disposable ink pens
Pouncing tool
type
Pouncing tool: PPA33-TP12, 1.2-mm pin diameter)
*4
Compatible
media
Mono-vinyl chloride media, fluorescent media, and reflective media up to 0.25 mm thick, high
reflective media.
*5
Compatible
paper for
pouncing
Regular paper from 0.06 to 0.13 mm thick
Interface USB2.0 (Full Speed)/Network (Ethernet 10BASE-T/100BASE-TX)
*3
/
RS-232C (Auto switching)
Buffer
memory
2 MB
Resident
command
sets
GP-GL/HP-GL
*2
(Control panel switching)
LCD display Graphic type (Yellow backlight)
Power supply 100-240VAC/50-60 Hz (Auto switching)
Power
consumption
160VA max.
Operating
environment
10 to 35º C, 35 to 75% R.H. (non-condensing)