GRAPHTEC FC8000 Series - Selecting Tool Condition; Setting the Tool Condition

2-24
2
-
2-25
Selecting Tool Condition
9
Tool conditions can be set in 8 settings from 1 to 8. Then, you can switch between 8 predefined different
setting for different media by switching the settings.
Operation
Supplement
Name of the media assigned in "Cutting Plotter
controller" is displayed as the CONDITION No.
name.
CONDITION No. can also be changed from
READY status. See "Changing CONDITION
No."
P.3-6
.
l
l
1
Press the [CONDITION] key in the default screen.
CONDITION setting screen (1/3) is displayed.
Supplement
It will return to CONDITION screen without
changing the settings when you press the
POSITION (
◄
) key (CANCEL).
2
Press the [1] key.
CONDITION No. selection screen is displayed.
3
Press the POSITION (
▲▼
) key and select the setting
(CONDITION No.).
POSITION
4
Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to CONDITION screen (1/3).
5
Press the [CONDITION] key.
It will return to the default screen.
Setting the Tool Condition
Supplement
See the appropriate references for details about
the "Setting Cut Line Pattern"
P.7-15
,
"Setting the Tangential Emulation"
P.7-3
,
"Setting Length of the Overcut"
P.7-4
,
"Setting the Distance Adjust"
P.7-13
, and
"Setting of the Initial Down Force"
P.7-6
.
See "Adjust the Blade Length Manually"
P.2-31
and "Adjust the Blade Length
(Automatic Height Adjust)"
P.2-36
for blade
length adjustment methods.
l
l
This section describes how to make the tool, speed, force,
acceleration, and tool number settings.
Before cutting media, the following five cutter-pen conditions must
be specified.
(1) Cutter-blade length ............. Adjust the blade length by referring
to the media thickness table below.
(2) FORCE ................................ Set the FORCE by referring to the
table below.
(3) SPEED: ................................ Set the SPEED by referring to the
table below.
(4) QUALITY ............................. Set the QUALITY by referring to the
table below.
(5) OFFSET ............................... Set to suit the cutter blade being
used.