2-24
2-25
Optimal Cutting Conditions for Each Media Type
Media type
Thickness
(mm)
Blade used Force Speed QUALITY
Film for outdoor use 0.05 ~ 0.08 CB09UA 10 ~ 14
30 or
under
3 ~ 4
Film for decorative use 0.08 ~ 0.1 CB09UA 14 ~ 17
30 or
under
3 ~ 4
Film for outdoor use 0.05 ~ 0.08 CB15UB 10 ~ 14
20 or
under
1
Transparent or
semitransparent film
0.08 ~ 0.1 CB09UA 14 ~ 20
30 or
under
3 ~ 4
Reflective film 0.08 ~ 0.1 CB09UA 14 ~ 20
30 or
under
3 ~ 4
Fluorescent film 0.20 ~ 0.25 CB09UA, CB15U 20 ~ 24 10 ~ 20 2 ~ 3
Thick materials 0.5 ~ 0.1 CB15U-K30 17 ~ 24 5 ~ 15 2 ~ 3
High-intensity reflective
film
0.25 ~ 0.3 CB15UA 24 ~ 35 5 ~ 40 1
Paint protection film CB09UA 14 ~ 35 30 4
Blade Part Nos., Displayed Blade Types, and CUTTER OFFSET Values
Blade material/tool Blade type
LCD panel indication
Setting
range
Setting
value for
OTHER
Blade (tool) type
Default
value
Ultra-hard blade
CB09UA CB09U 0 ±5 18
CB15U-K20-SP CB15-10U 0 ±5 28
CB15U CB15U 0 ±5 28
CB15UA CB15U 0 ±5 28
CB15UB CB15UB 0 ±5 5
CB15U-K30 CB15U-K30 0 ±5 28
Other OTHER 1 1 ~ 45 –
Pen PEN N/A N/A 0
Pouncing POUNCE
0.0 mm
(between the
holes)
1 ~ 99 –
Light Pointer LIGHT POINTER N/A N/A 0
When a blade type has been selected, the OFFSET is automatically adjusted by ±5 with respect to the default
cutter offset value for that blade type.
Select OTHER to use settings other than those displayed for hard-to-cut media. Select PEN when a plotting pen
has been mounted in the plotter. Select POUNCE when a pouncing tool has been mounted in the plotter.
Reference Pen Conditions for Plotting Pens
Pen type Part no. FORCE
SPEED
(cm/s)
QUALITY
Water-based fiber-tip pen KF550 Series 10 ~ 12 30 4
Disposable ink pen SD pens (PHP33-INK) 7 ~ 8 20 2
Oil-based ballpoint pen KB140 Series (PHP31-BALL) 21 • 22 60 4
To prolong the pen life, set the FORCE to the lowest setting, and set the SPEED after checking to confirm that
there are no faint lines or other problems during plotting.
To Next Page
Loading...
