GRAPHTEC FC8000 Series - Cut off the Roll Sheet (Cross Cut); Cut Width

3-14
3
-
3-15
Cut off the Roll Sheet (Cross Cut)
6
Operation to cut off the media is called cross cut.
It is possible to cut at any location manually, or to automatically cut when the cutting is completed. Force
of the blade when the cross cut is made is called cross cut force, and it can be adjusted.
CAUTION
Do not place your hand where the blade might move. You may be injured.
Reference
Only when the roll media is loaded by rear loading can be cross cut. Cross-cutting cannot be performed for the media that was front loaded or
SHEET has been specified.
Periodically clean out the groove with a cotton swab or similar item. Cutter will not operate properly if dust or dirt builds up in the cutting groove.
Remove the media if it is resting on the media sensor after it was cross cute. If this is not removed, it is determined that the cut was not
performed properly, and it will cross cut again.
Set the "setting for the push roller sensor" and the "setting for the media sensor" in the basic settings to enabled. It cannot perform cross cut if
it is set to disabled.
l
l
l
l
Cut Width
The range of the blade movement for cross cut is 92 mm outside the leftmost push roller, and 32 mm outside
the rightmost push roller. Set the media within this area.
Supplement
Replace the cross cut unit with following as a
guideline.
Paper back film: 1000 mm width media, about
3000 sheets (CT01H)
Plastic back film: 1000 mm width media, about
3000 sheets (CT01H)
l
l