6
-
6-3
Manual Position Adjust
2
Method of manual position adjust is described here.
Supplement
Adjustment will be cleared if following is done after setting the adjustment.
· Set new origin point.
· Reload the media.
· Set rotation or mirror. (Set the rotation or mirror prior to the axis adjustment)
Axis adjustment will convert in accordance with rotation or mirror in this case.
"AXIS SET ERROR! SET AGAIN" is displayed if the tilt of the axis at point 1 and point 2, point 1 and point 3, point 3 and point 4, or point 2 and
point 4 is too large. Reload the media so it is not tilted as much, and redo the adjustment.
Axis adjustment will be cleared when point 1 and point 2 is set to same point.
l
l
l
Next page
Supplement
Confirm that the push roller is steadily on the
media within the range of media movement. This
adjustment is based on assumption that media is
slightly tilted. Media might fall off if the tilting of the
media is too large.
1
Load the media with adjustment mark in the plotter.
P.2-6
Loading Media (Paper or Marking Film)
Supplement
See "Attaching the Loupe"
P.14-2
for attaching
the magnifier.
2
To use the loupe for adjustment, set the loupe (optional) on the
tool holder.
P.5-6
Setting MARK SCAN Mode and Numbers
3
Set the paper-weight as needed.
P.7-21
Setting Paper-Weight
4
Press the [MENU] key.
MENU screen is displayed.
5
Press the [2] key (ARMS).
ARMS SETTING screen (1/4) is displayed.
To Next Page
Loading...
