GRAPHTEC FC8000 Series - 4-1 Settings for Cutting

4-2
4
-
4-3
Settings for Cutting
Settings such as area and width of cutting, page length, mirrored, enlarged, shrunk, etc., can be set.
Setting Cutting Area
Supplement
See "Setting the Origin Point"
P.3-7
about
the moving the origin point.
See"Setting Origin Point When HP-GL is Set"
P.3-9
for setting the origin point with HP-
GL command.
l
l
Origin point will be set at lower left of the AREA once the AREA is
set. It is possible to set the origin point at the center when the HP-
GL is selected.
Move the origin point to change the cutting position.
<For rear loading/sheet>
It will only cut
within this range
Upper right
set position
Origin point
Image already cut
Supplement
For the front loading model, rotate the above figure 180 degrees.
Next page
Operation
Supplement
See "How to Use Control Panel"
P.2-17
for
READY status.
1
Press the [MENU] key in READY status.
MENU screen is displayed.
2
Press the [3] key (AREA).
AREA PARAMETERS setting screen (1/2) is displayed.
1