GRAPHTEC FC8000 Series - When Coordinate Axes Rotation Are Set; When Coordinate Axes Are Rotated after Origin Point Is Set

3-8
3-9
When Coordinate Axes Rotation are Set
If the origin point is moved while the coordinate axes are rotated, the origin point will move as shown below.
Supplement
See "Setting the Cutting Direction"
P.3-10
about the rotation of the coordinate axes.
Supplement
For the front loading model, rotate the above
figure 180 degrees.
Original origin point
<For rear loading/sheet>
New origin
point
When Coordinate Axes are Rotated After Origin Point is Set
The origin point will be initialized as shown below if the coordinate is rotated after moving the origin point.
Distance "a" will be maintained, but distance "b" will be initialized.
<For rear loading/sheet>
Original origin point
a
New origin point
Before setting
a
b
Original origin point
After setting
Supplement
For the front loading model, rotate the above figure 180 degrees.
To use the origin point movement and coordinate axes rotation together, always rotate the coordinate axes first, and then move the origin point.
Coordinate value displayed after setting new origin point is a distance from the new origin point.
l
l
l