GRAPHTEC FC8000 Series - Setting the Tangential Emulation

7-2 7-3
Setting the Tangential Emulation
On/off and the mode of the tangential emulation can be set individually for each of 1-8 tool control
numbers.
Operation
1
Press the [CONDITION] key.
CONDITION setting screen (1/3) is displayed.
Supplement
It will return to default screen without changing the
settings when you press the [CONDITION] key.
2
Press the POSITION (
▼
) key.
POSITION
CONDITION setting screen (2/3) is displayed.
3
Press the [4] key (TANGENT EMULATION).
TANGENT EMULATION setting screen is displayed.
4
Press the POSITION (
◄►
) key and select the CONDITION No.
POSITION
5
Press the [1] key (MODE1), the [2] key (MODE2), or the [3] key
(OFF) and select the mode.
Supplement
It will return to CONDITION screen (2/3) without
changing the settings when you press the [4] key
(CANCEL).
6
Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to CONDITION screen (2/3).
7
Press the [CONDITION] key.
It will return to default screen.