GRAPHTEC FC8000 Series - Enabling;Disabling the Push Roller Sensors (PUSH ROLLER SENSOR)

10-4
10-5
Enabling/Disabling the Push Roller Sensors (PUSH ROLLER SENSOR)
This function enables or disables the push roller sensors that detect the width of the media.
Operation
1
Press the [MENU] key in the default screen.
MENU screen is displayed.
2
Press the POSITION (
▼
) key (ADV.).
POSITION
ADVANCE setting screen (1/3) is displayed.
3
Press the POSITION (
▼
) key.
POSITION
ADVANCE setting screen (2/3) is displayed.
4
Press the [1] key (PUSH ROLLER SENSOR).
PUSH ROLLER SENSOR setting screen is displayed.
Supplement
All the sensors are disabled when DISABLED is
selected. It will not generate error even if the inner
push rollers are not on the grit rollers when the
INSIDE DISABLED is selected.
5
Press the [1] key (ENABLED), the [2] key (INSIDE DISABLED),
or the [3] key (DISABLED).
Supplement
Push roller sensor is used for the cross cut too,
so it will not be able to cross cut when it is set to
DISABLED.
Position of the home sensor is not also
detected, so there is a danger of clashing
depending on the data. Use with "AREA" set.
l
l
6
Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to ADVANCE setting screen (2/3).
7
Press the [MENU] key.
It will return to the default screen.