GRAPHTEC FC8000 Series - Test the Registration Mark Sensor

5-20
5-21
10
Confirm the setting and press the POSITION (
◄
) key
(PREVIOUS).
POSITION
DETECTION THRESHOLD is selected and it will return to
DETECTION THRESHOLD adjusting screen.
Supplement
It will return to ARMS setting screen (4/4) without
changing the settings when you press the
POSITION (
◄
) key (CANCEL).
11
Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to ARMS setting screen (4/4).
12
Press the [MENU] key.
It will return to default screen.
Test the Registration Mark Sensor
CAUTION
This function performs cutting after the registration
mark is scanned. If a cutter is used as the tool, it
may harm the plotter.
If there still is a difference in the cutting, even after performing an
adjustment using the registration mark, it is possible to check if
there is a problem with the registration mark itself or the application
by evaluating the position of the registration mark plotted and
detected only using the plotter.
Next page
Operation
Supplement
Print the "Test Pattern 1" to test MARK TYPE 1,
and "Test Pattern 2" to test MARK TYPE 2.
Standard registration mark is inside the "ARMS
Test Files" folder of the accessory CD.
Registration
Mark
File
Format
File Name
MARK TYPE 1 pdf ARMStest_type1.pdf
eps ARMStest_type1.eps
MARK TYPE 2 pdf ARMStest_type2.pdf
eps ARMStest_type2.eps
l
l
1
Print the standard registration mark in the accessory CD.
MARK TYPE 1 MARK TYPE 2
Supplement
See "Loading Media (Paper or Marking Film)"
P.2-6
for loading the media.
2
Load the printed media onto the plotter.
3
Press the [MENU] key.
MENU screen is displayed.
4
Press the [2] key (ARMS).
ARMS setting screen (1/4) is displayed.