5-22
5
Press the POSITION (
▲
) key.
ARMS setting screen (4/4) is displayed.
Supplement
It will return to TOOL setting screen (3/3) without
changing the settings when you press the [3] key
(CANCEL).
6
Press the [4] key (TEST ARMS SENSOR).
TEST ARMS SENSOR screen is displayed.
Supplement
It will return to TOOL setting screen (3/3) without
changing the settings when you press the [4] key
(CANCEL).
7
Press either the [1] key (TYPE 1) or the [2] key (TYPE 2)
depending on the type of the registration mark to be used.
Following message is displayed.
8
Move the tool to the position to start scanning of the registration
mark by pressing the POSITION (
▲▼◄►
) key.
MARK TYPE 1 MARK TYPE 2
Feed direction of media
Move the tool inside this area Move the tool inside this area
Feed direction of media
Registration mark scan area
Supplement
Following error is displayed when the registration
mark was not scanned properly. Press the [1]
key (SCAN AGAIN) to scan again, or the [2] key
(CANCEL) to exit.
9
Confirm the position of the tool and press the [ENTER] key.
The plotter will automatically detect the registration mark and cut the peak of
each registration marks.
10
Confirm the cutting result.
See "Adjusting for the Registration Mark Scan Position" P.5-24 and adjust if
the cutting position is shifted. See "Adjusting the Sensor Level" P.5-18 and
adjust if the registration mark cannot be scanned.
To Next Page
Loading...
