GRAPHTEC FC8000 Series - To Make 3 Cuts with Set Value and ±1 of Set Value

2-34 2-35
To make 3 cuts with set value and ±1 of set value
Operation
1
Load the media for test cutting in the plotter.
2
Press the [CONDITION] key in the default screen.
CONDITION screen (1/3) is displayed.
Supplement
It will return to CONDITION screen (1/3) by
pressing the [4] key (CANCEL).
3
Press the POSITION (
►
) key (CUT TEST).
CUT TEST screen is displayed.
4
Press the POSITION (
▲▼◄►
) key the tool carriage to the
location you wish to perform the test cutting.
POSITION
CAUTION
When the [1] key (FORCE) is pressed, the tool
carriage will start moving, so take care not to cut
your fingers.
5
Press the [1] key (FORCE).
3 cutting test patterns are cut, with current FORCE in the center, and 1 each
of FORCE increased and decreased for 1.
6
Press the [ENTER] key after completion.
It will return to CUT TEST menu screen.
CAUTION
When the [2] key (CUTTER OFFSET) is pressed,
the tool carriage will start moving, so take care not
to cut your fingers.
7
Press the [2] key (CUTTER OFFSET).
3 cutting test patterns are cut, with current CUTTER OFFSET in the center,
and 1 each of CUTTER OFFSET increased and decreased for 1.
8
Press the [ENTER] key after completion.
It will return to CUT TEST menu screen.
9
Press the [CONDITION] key.
It will return to the default screen.