7
-
7-21
Hold the media down against the cutting surface by turning on the PAPER-WEIGHT to prevent decrease of the
quality by the media rising up during scanning of the registration marks.
Turn it off when you need to prevent the smudging of the ink by the PAPER-WEIGHT.
Paper-weight is located under the tool carriage. (It cannot be seen from outside)
Supplement
The registration mark may not be scanned correctly if the paper-weight is set to OFF.
Periodically clean the paper-weight using cotton swab or similar. It may smudge the media if it is dirty.
l
l
Next page
1
Press the [MENU] key.
MENU screen is displayed.
2
Press the [2] key (ARMS).
ARMS SETTING screen (1/4) is displayed.
3
Press the POSITION (
▼
) key twice.
ARMS SETTING screen (3/4) is displayed.
Setting Paper-Weight
8
To Next Page
Loading...
