GRAPHTEC FC8000 Series - Perform Automatic Pre Feed When Media Is Set (Initial Feed)

8-6
8
-
8-7
Perform Automatic Pre Feed When
Media is Set (Initial Feed)
Supplement
Setting for the INITIAL FEED is maintained even if
the power is turned off.
It can be set to automatically feed and return the length of the
page when the media is loaded and the media set lever is raised.
This is equal to automatically perform the "Pre Feed" to prevent
the shifting of the media.
P.2-23
"Pre Feed of Media (Paper or Marking Film)"
P.8-4
"Perform Automatic Pre Feed When Cut Data is Received"
P.8-7
"Setting Feed Speed for Media Set"
Operation
1
Press the [MENU] key.
MENU screen is displayed.
2
Press the [4] key (MEDIA).
MEDIA SETTING screen (1/2) is displayed.
3
Press the [4] key (INITIAL FEED).
INITIAL FEED screen is displayed.
4
Set the mode by pressing the [1] key (ON) or the [2] key (OFF).
Supplement
It will return to MEDIA SETTING screen (1/2)
without changing the settings when you press the
POSITION (
◄
) key.
5
Confirm the setting and press the [ENTER] key.
Setting will be set, and it will return to MEDIA SETTING screen (1/2).
6
Press the [MENU] key.
It will return to default screen.
3