It will copy in following order when COORDINATE AXES ROTATION is set.
Supplement
For the front loading model, rotate the above
figure 180 degrees.
<For rear loading/sheet>
First copy
Second
copy
Origin point
Copy
space
Copy space
Copy origin point
First cut
Third copy
Fourth
copy
Fifth copy Sixth copy
Next page
1
Create one data you want to copy.
Cutting data is stored in the buffer memory.
2
Press the POSITION (
▲▼◄►
) key and move the tool carriage
to the position to copy.
Supplement
"NO DATA FOR COPY IN BUFFER!" is
displayed if there is no data in the buffer
memory. Send the cutting data.
"COPY MODE BUFFER FULL! CANNOT
COPY" is displayed if the data sent was bigger
than what can be stored in the buffer memory.
l
l
3
Press the [COPY] key.
COPY MODE screen is displayed.
4
Press the [1] key (NUMBER OF COPIES).
NUMBER OF COPIES setting screen is displayed.
Supplement
Number of copies can be set from 1 to 100, as
much as it can fit in the media set on the printer.
5
Press the POSITION (
▲▼
) key and increase or decrease the
setting value.
To Next Page
Loading...
