4-11
Supplement
"CANNOT COPY CUT AREA TOO SMALL!" is
displayed if the cutting area is smaller than the
copy data. Either expand the cutting area, or set
the media that is big enough to copy.
6
Confirm the setting and press the POSITION (
◄
) key
(PREVIOUS).
Number of copies will be selected, and it will return to COPY mode screen.
Supplement
Copy space can be set from 1.0 mm to 10.0 mm.
This setting is maintained even if the power is
turned off.
l
l
7
Press the [2] key (COPY SPACE).
COPY SPACE setting screen is displayed.
8
Press the POSITION (
▲▼
) key and increase or decrease the
setting value.
9
Confirm the setting and press the POSITION (
◄
) key
(PREVIOUS).
Copy space will be selected, and it will return to COPY mode
screen.
Supplement
Cutting data is stored even if the media is
exchanged. It can be copied as many times until
the buffer memory is cleared. It can be copied
again after exchanging the media by pressing
[COPY] key.
10
Confirm the setting and press the [ENTER] key (SET).
"COPY" is displayed on the screen, and it will copy as much as specified.
To Next Page
Loading...
