GRAPHTEC FC8000 Series - Page 126

5-24
5-25
Next page
5
Press the POSITION (
▼
) key twice.
POSITION
ARMS SETTING screen (3/4) is displayed.
Supplement
It will return to ARMS setting screen (3/4) without
changing the settings when you press the
POSITION (
◄
) key (CANCEL).
6
Press the [1] key (SENSOR OFFSET ADJ.).
SENSOR OFFSET ADJ. setting screen is displayed.
7
Press the [1] key (TEST PATTERN).
Following message is displayed.
8
Press the POSITION (
▲▼◄►
) key and move the tool carriage
to the position to plot the registration mark (position nothing is
printed).
POSITION
Supplement
It will return to SENSOR OFFSET ADJ. screen
without plotting by pressing the [4] key (CANCEL).
9
Press the [ENTER] key.
Registration mark is plotted.
10
Confirm that the tool is at the position shown in the left image,
and press the [ENTER] key.
It will read the registration mark, and then plot the registration mark for
comparison. It will return to SENSOR OFFSET ADJ. screen once the plotting
is completed.
Feed direction of media
Registration mark
for comparison
Y
X
Registration mark for adjustment
Distance adjustment value Y
Distance
adjustment
value X
Feed direction of media
Align the tool to this area
Y
X