Chapter 7: Setting Regarding Cutting Quality .........................................7-1
7-1 To cut the corner of thick media sharply ....................................................................................7-2
Outline of Tangential Emulation ..................................................................................................7-2
Setting the Tangential Emulation ................................................................................................7-3
Setting Length of the Overcut ......................................................................................................7-4
Setting of the Initial Down Force .................................................................................................7-6
Setting the TOOL UP HEIGHT ......................................................................................................7-7
7-2 Setting the Step Pass ...................................................................................................................7-9
7-3 Setting the Reference Angle ......................................................................................................7-11
7-4 Setting the Distance Adjust .......................................................................................................7-13
7-5 Setting Cut Line Pattern .............................................................................................................7-15
7-6 Setting Initial Blade Direction Adjust ........................................................................................7-18
7-7 Settings for OFFSET FORCE ......................................................................................................7-20
7-8 Setting Paper-Weight .................................................................................................................7-21
Chapter 8: Settings Regarding Cutting Time ..........................................8-1
8-1 Sorting the Cutting Data ...............................................................................................................8-2
8-2 Perform Automatic Pre Feed When Cut Data is Received ........................................................8-4
8-3 Perform Automatic Pre Feed When Media is Set (Initial Feed) .................................................8-6
8-4 Setting Feed Speed for Pre Feed.................................................................................................8-7
8-5 Setting the Tool Up Speed ...........................................................................................................8-9
8-6 Setting the Tool Up Move ...........................................................................................................8-11
Chapter 9: Setting Regarding Interface ...................................................9-1
9-1 Setting Interface ............................................................................................................................9-2
USB Interface ................................................................................................................................9-2
RS-232C Interface .........................................................................................................................9-2
Network (LAN) Interface ...............................................................................................................9-2
Interface Setting Menu .................................................................................................................9-3
Connecting with Network (LAN) ..................................................................................................9-3
When DHCP Setting is Turned Off ............................................................................................9-4
Connecting with RS-232C ............................................................................................................9-6
Switching Setting Numbers ......................................................................................................9-6
Changing and Storing RS-232C Settings ....................................................................................9-7
Chapter 10: Settings Regarding Operation Environment ....................10-1
Related to Menu Display ............................................................................................................10-2
Display Language Setting (LANGUAGE SELECTION) ..........................................................10-2
Setting the Display Length Unit (LENGTH UNIT) .................................................................10-3
Related to Sensor .......................................................................................................................10-4
Enabling/Disabling the Media Sensors (MEDIA SENSOR) ...................................................10-4
Enabling/Disabling the Push Roller Sensors (PUSH ROLLER SENSOR) ............................10-5
Related to Plotter Environment .................................................................................................10-6
Fan Suction Setting (FAN POWER) .........................................................................................10-6
Enabling/Disabling the Beep Setting (BEEP FOR KEY OPERATION) .................................10-7
Chapter 11: Settings of Controls from Computer .................................11-1
Related to Command Processing .............................................................................................11-2
Setting the Command (COMMAND) .......................................................................................11-2
Priority of Tool Condition Selection (CONDITION PRIORITY) ............................................11-3
Enabling/Disabling the Pen Select Command (PEN SELECT) ...............................................11-4
To Next Page
Loading...
