GRAPHTEC FC8000 Series - Page 111

5-10
5-11
2
Press the [2] key (ARMS).
ARMS setting screen (1/4) is displayed.
3
Press the POSITION (
▼
) key.
POSITION
ARMS SETTING screen (2/4) is displayed.
Supplement
It will return to ARMS setting screen (2/4) without
changing the settings when you press the
POSITION (
◄
) key (CANCEL).
4
Press the [1] key (MARK TYPE).
MARK TYPE setting screen is displayed.
Supplement
MARK TYPEs that the plotter can detect are 2
types shown in bottom left figures.
6
Press the [1] key (TYPE1) or the [2] key (TYPE2).
MARK TYPE 1 MARK TYPE 2
Feed direction of media
Feed direction of media
Cut area
Feed direction of media
Supplement
It will return to ARMS setting screen (2/4) without
changing the settings when you press the
POSITION (
◄
) key (CANCEL).
7
Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to ARMS setting screen (2/4).
8
Press the [MENU] key.
It will return to the default screen.