5-30 5-31
Supplement
See "Loading Media (Paper or Marking Film)"
P.2-6
for loading the media.
1
Load the media with registration marks (2POINTS) plotted.
2
Set the MARK SCAN MODE to ARMS, and POINTS to
2POINTS.
P.5-6
Setting MARK SCAN Mode and Numbers
Supplement
It is not necessary to set the MARK DISTANCE
when it is adjusted manually.
3
Set the shape and size of the registration mark, mark distance,
distance adjust mode, offset, paper-weight, sensor level, scan
position adjustment, etc., as needed.
P.5-9
Setting Shape (Pattern) of Registration Mark
P.5-11
Setting Registration Mark Size
P.5-12
Setting Mark Distance
P.5-14
Setting Distance Adjustment Between the Registration Mark
P.5-16
Setting Offset Between the Registration Mark and Cutting Origin Points
P.5-18
Adjusting the Sensor Level
P.5-19
Manually Adjusting the Sensor Level (Threshold Value)
P.7-21
Setting Paper-Weight
4
Press the [MENU] key.
MENU screen is displayed.
5
Press the [2] key (ARMS).
ARMS SETTING screen is displayed.
Steps are different from here depending if it is going to move to
registration mark automatically to scan the registration mark, or
if it is going to move manually to scan. See next section.
P.5-34
Automatically Adjust
P.5-36
Adjust Manually
To Next Page
Loading...
