GRAPHTEC FC8000 Series - Page 184

9-4
9-5
Next page
5
Repeat steps 3 to 5 and select the 4 values to be set.
6
Confirm the setting and press the [4] key (PREVIOUS).
IP ADDRESS will be set, and it will return to LAN setting screen.
Supplement
Digits of settings can be changed by pressing
the [FAST] key.
7
Press the [3] key (SUBNET MASK).
SUBNET MASK setting screen is displayed.
8
Press the POSITION (
◄►
) key, and select the value to be set.
POSITION
Supplement
Digits of settings can be changed by pressing
the [FAST] key.
9
Press the POSITION (
▲▼
) key, and increase or decrease the
values in the digits to be set.
POSITION
10
Repeat steps 8 to 9 and select the 4 values to be set.
11
Confirm the setting and press the [4] key (PREVIOUS).
SUBNET MASK will be set, and it will return to LAN setting screen.
12
Press the [4] key (GATEWAY).
GATEWAY setting screen is displayed.
13
Press the POSITION (
◄►
) key, and select the value to be set.
POSITION
Supplement
Digits of settings can be changed by pressing
the [FAST] key.
14
Press the POSITION (
▲▼
) key, and increase or decrease the
values in the digits to be set.
POSITION
15
Repeat steps 13 to 14 and select the 4 values to be set.
16
Confirm the setting and press the [4] key (PREVIOUS).
GATEWAY will be set, and it will return to LAN setting screen.
17
Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to INTERFACE setting screen (2/3).