13-4
Symptom Possible Cause Solution Reference
Displays command error. Data sent to the plotter is
not correct.
Check the data.
P.13-6
Error
Message in GP-GL
Command Mode
P.13-7
Error
Message in HP-GL
Command Mode
It cannot cut above
certain length.
Length of the cut is
exceeding the length of the
page set on the plotter.
Press the [ENTER] key and
check the cutting area.
Match the setting for the page
length.
P.4-5
Setting
Length of the Page
There are too many tool
up and down.
Setting for the tangential
emulation is set to ON.
Turn OFF the setting for the
tangential emulation unless you
are cutting thick media.
P.7-3
Setting the
Tangential Emulation
It is cutting on the grit
roller imprint.
Cutting width is widened. Set the setting of the cutting
width to 0.
P.4-4
Setting
Cutting Width
Cannot change the tool
condition.
Setting for the sorting is set
to ON.
Normally, use the plotter with
setting for the sorting OFF.
P.8-2
Sorting the
Cutting Data
Tool condition changes. Setting of the priority is set
to PROGRAM.
Change the setting of the
priority to MANUAL.
P.11-3
Priority of Tool
Condition Selection
(CONDITION
PRIORITY)
[ENTER] key is not pressed
after changing the TOOL
CONDITION.
Check the TOOL CONDITION
again.
P.2-24
Setting the
Tool Condition
Media travels tilted. Media is loaded tilted. Reload the media.
P.2-6
Loading
Media (Paper or
Making Film)
Media is slipping. Perform pre feed once and
make impression to make it
harder to slip.
P.2-23
Pre Feed
of Media (Paper or
Marking Film)
It does not become
specified length. (Slight
distance error)
Media is slipping. Make the speed slower.
Increase the tool up speed.
Perform feeding.
P.2-24
Setting the
Tool Condition
P.2-23
Loading
Media (Paper or
Marking Film)
P.8-9
Setting the
Tool Up Speed
Distance adjust value is not
correct.
Perform distance adjust.
P.7-13
Setting the
Distance Adjust
"LOAD MEDIA!" is
displayed even if the
media is set and media
set lever is moved up.
Media is close to
transparent and media
sensor makes false
recognition. (This may
happen depending on the
media.)
Transparent media cannot be
detected. DISABLE the media
sensor and set the cut area
when this kind of media is used.
P.10-4
Enabling/
Disabling the Media
Sensors (MEDIA
SENSOR)
P.4-2
Setting
Cutting Area
Media sensor malfunctions
with strong scattered
reflection.
Move the position of the light
source.
Make is so no direct sunlight
shines.
There may be defective in
the operation of the media
set lever sensor.
Contact your sales
representative or the Graphtec
call center.
To Next Page
Loading...
