13-13
Symptom LCD Display Possible Cause Solution
E01015 The plotter is defective. Contact your sales representative
or the Graphtec call center.
E01017 The plotter is defective.
Load on the motor was too large.
Move the object disturbing the
operation, and turn on the plotter
after turning it off once.
Do not use heavy media.
E01018 The plotter is defective.
Load on the motor was too large.
Move the object disturbing the
operation, and turn on the plotter
after turning it off once.
Do not use heavy media.
E01019 The plotter is defective.
Load on the motor was too large.
Move the object disturbing the
operation, and turn on the plotter
after turning it off once.
Do not use heavy media.
E05001 Data larger than the buffer size
cannot be copied.
Perform normal cutting not using
the copy mode.
E05002 There is no data to copy. Perform normal cutting by sending
the data, then use the copy mode.
E05003 Media valid area to copy is too
small.
Use larger media.
E05004 The push roller is not on the grit
roller.
Set the push roller on the grit
roller.
E05005 It has failed to cross cut. The media was not cut off. Check
the blade for the cross cut. Check
the media on the writing panel.
E05006 Distance between the bottom left
and top right of the AREA setting
is less than 5 mm.
Perform the AREA setting again.
E05007 Test pattern for the TOOL
OFFSET ADJ. cannot start
plotting because the start position
is at the edge of the media.
Set the start position inside the
media.
To Next Page
Loading...
