GRAUPNER mz-24 PRO - Page 50

Tip
Remember that the input/output percentages in
the IN and OUT lines always refer to the momen-
tary position of the control stick and not to the
position of the point.
Rounding Off the Throttle Curve
• Curve Line ON/OFF Button
The default angled curve profile can be au-
tomatically rounded off by turning on the
rounding function by pressing the ON/OFF
button in the Curve line, as shown below:
NORMAL
PIT.CRV
WIZ.
IN
OUT
POINT
OFF
INC
ENT
DEC
Y-axis
TRIM
X-axis
ST ON
Curve
2
–044%
+027%
+044%
Pitch min.
FORWARD
Press
NORMAL
PIT.CRV
WIZ.
IN
OUT
POINT
ON
INC
ENT
DEC
Y-axis
TRIM
X-axis
ST ON
Curve
2
–044%
+027%
+044%
Pitch min.
FORWARD
Notice
The curves portrayed here are for demon-
stration purposes only and do not repre-
sent real pitch curves.
• TRIM Button
The mz-24 Pro transmitter software has a
function that is integrated in the helicopter pro-
gram for trimming during flight up to six sup-
port points of the two options "throttle curve"
and "pitch curve".
Open the following window by touching
the TRIM button at the top right edge of the
display:
WIZ.
CTL
NONE
INC
RES
DEC
MIXER
NONE
POINT PHASE
L
1
NONE
NONE
L
1
NONE
NONE
L
1
NONE
NONE
L
1
NONE
NONE
L
1
NONE
NONE
L
1
Basic Operating Steps
• CTL Column
Use the first column to select a control that
appears suitable for the controls offered by
the transmitter.
To assign a control, press the button in the
CTL column along the appropriate row:
WIZ.
CTL
NONE
INC
RES
DEC
MIXER
NONE
POINT PHASE
L
1
NONE
NONE
KEIN
1
NONE
NONE
KEIN
1
NONE
NONE
KEIN
1
NONE
NONE
L
1
NONE
NONE
L
1
Select
CLR
NO
Press
An active warning window will appear:
WIZ.
CTL
NONE
INC
RES
DEC
MIXER
NONE
POINT PHASE
L
1
NONE
NONE
KEIN
1
NONE
NONE
KEIN
1
NONE
NONE
KEIN
1
NONE
NONE
L
1
NONE
NONE
L
1
Select
CLR
NO
Press to scroll through the control options.
In this example, the right proportional rotary
control SL1 is selected:
WIZ.
CTL
SL 1
INC
RES
DEC
MIXER
NONE
POINT PHASE
L
1
NONE
NONE
L
1
NONE
NONE
L
1
NONE
NONE
L
1
NONE
NONE
L
1
NONE
NONE
L
1
• MIXER Column
Use the second column to select individu-
al helicopter mixers, or one of the two avail-
able mixers in any combination.
To select a mixer, press the button in the
MIXER column along the appropriate row:
WIZ.
CTL
SL 1
INC
RES
DEC
MIXER
NONE
POINT PHASE
L
1
NONE
NONE
L
1
NONE
NONE
L
1
NONE
NONE
L
1
NONE
NONE
L
1
NONE
NONE
L
1
Press
The button will highlight blue:
50 Base menu - Model selection