Hakko Electronics Monitouch V9 Series User Manual

16.2 Temperature Controller/Servo/Inverter Connection 16-63
*1 Select “Modbus RTU” for the communication protocol on the inverter when connecting with the V9.
*2 When “0” is specified for y98 (bus function) as well as y99 (support link function), the frequency and operation command can be set on
the V9.
When making frequency and operation command settings on the V9 connected to the connector for the touch panel, specify “3” for
function code H30. When making the settings on the V9 connected to the control circuit terminal block, specify “8” for H30.
*3 The communication parameter (data length) is fixed to 8 bits.
Available Device Memory
The available setting range of device memory varies depending on the model. Be sure to set within the range available for the
model to be used. Use [TYPE] when assigning indirect device memory for macro programs.
y99 Support link function 0
H30
Link function
*2
3
Function Code Item Setting Example
Frequency Operation Command
0 Function code H30, y98 Function code H30, y98
1
Commanded from FRENIC
loader
Function code H30, y98
2 Function code H30, y98
Command from FRENIC
loader
3
Command from FRENIC
loader
Command from FRENIC
loader
Frequency Operation command
0 Inverter Inverter
1 RS-485 communication Inverter
2 Inverter RS-485 communication
3 RS-485 communication RS-485 communication
4
RS-485 communication
(Control circuit)
Inverter
5
RS-485 communication
(Control circuit)
RS-485 communication
6Inverter
RS-485 communication
(Control circuit)
7 RS-485 communication
RS-485 communication
(Control circuit)
8
RS-485 communication
(Control circuit)
RS-485 communication
(Control circuit)
Device Memory TYPE Remarks
402H

Hakko Electronics Monitouch V9 Series Specifications

General

Brand	Hakko Electronics
Model	Monitouch V9 Series
Category	Monitor
Language	English