7-4
pH, mV & ISE MODE
7.1 pH Mode
7.1.1 Display
The
pH
screen is shown below with short explanations of the screen segments.
pH Mode Option keys:
The General Options screen gives access to options that are not directly related to
the measurement process (see chapter
4 General Options
for more information).
Stores the current pH reading (see section
7.4.2 Manual
Logging
).
or
Starts the pH automatic log (see section
7.4.1 Automatic Logging
).
Enter the pH calibration screen (see section
7.1.3 pH Calibration
).
Enter the pH setup screen, parameters are associated with pH measurements and
calibration (see section
7.1.2 pH Setup
).
Allow the user to switch between the available measurement modes: Titrator, pH,
mV or ISE mode.
pH MODE
To Next Page
Loading...
