10
QUICK START GUIDE
HOW TO PERFORM A TITRATION
Required Solutions
• Titrant - 500 mL of 0.1 M (mol/L) Sodium Hydroxide (NaOH) in a titrant bottle.
• Sample - 0.1 mol/L Hydrochloric Acid (HCl).
• Distilled or deionized water.
Note: Analytical grade reagents and water should be used for accurate results.
Priming the Burette
• Insert the aspiration tube in the titrant bottle and the dispensing tube in a waste
beaker.
• From the main screen press .
• Highlight the
Prime Burette
option and then press .
• Enter the number of burette rinses. At least 3 rinses are recommended.
• Press to start.
• The message “Executing...” will be displayed.
Note: Make sure you have continuous liquid flow inside the burette. For accurate results, the
aspiration tube, the dispensing tube and the syringe must be free of air bubbles.
Method Selection
For this analysis we will use the HI1009EN Neutralization w/ NaOH
.
To select this method:
• Press . Use the and keys to highlight HI1009EN Neutralization w/ NaOH.
• Press .
To Next Page
Loading...
Need help?
General
