7-21
pH, mV & ISE MODE
7.3.2.2 Temperature Compensation
Enable or disable temperature compensation for ISE measurements.
Note: If you enabled Temperature Compensation, then the isopotential point must be set.
7.3.2.3 Isopotential Point
This option is available only if temperature compensation is enabled.
This option allows the user to set an isopotential point for the selected electrode. Ion selective
electrodes have different isopotential points. The isopotential point is edited in ppm units only.
The isopotential point should be entered if it is known and if measurements are going to be made
at several temperatures.
To Next Page
Loading...
