Operating instructions HERMA 400 O
VERVIEW
b
3.28 US (130519) 13/154
Warning symbols on the applicator
These symbols / hazard notification labels are used on the applicator:
Risk due to missing hazard notification labels.
Verify that all hazard
notification labels shown on the overview picture
are in place.
lf hazard notification labels are not present, this could lead to injuries.
Contact your HERMA representative before energizing your machine
Find information on safety messages in chapter 2 as of page 15.
Find comprehensive general information on safety in chapter 3 as of page 17.
1 Label roll
2 Label roll core
3 Label
4 Backing paper
3+4 Label web
Risk of electric shock. 110-240 Volts
may be present.
Disconnect all sources of supply and
wait for five minutes before opening
the rear cover or touching the
connector pins!
If components are worked while the
applicator is not disconnected from
mains on this could cause
electrocution.
In this specially designated area, work
must be performed only by trained
electricians. Unauthorized persons
are not permitted to open the
designated area.
Risk of being drawn in.
Do not
reach into the area where the
feed roller draws in the web when
machine is on!
This could lead to serious injuries.
To Next Page
Loading...
