Hettich HettCube 200 User Manual

en
12.2020 / Rev. 02
AB66005
64 / 174
Operation
PIN protection
Fig. 80: ‘Manual mode

PIN
protection’
1 [PIN protection] switch
Fig. 81: ‘Manual mode

PIN
protection

Admin PIN’
1 [Conrmation] button
2 Keypad
Control contact (option)
If no ‘Admin PIN’ was assigned, you will still be
asked for the ‘Admin PIN’ when activating the PIN
protection.
To activate the PIN protection, you will need the
‘Admin PIN’.
To set the PIN protection, proceed as follows:
1. Activate the
[PIN protection] switch.
2. Enter the
‘Admin PIN’ via the keypad and conrm the input
with the [Conrmation] button.

PIN protection is active.
The control contact is only available on incubators
with the Switchboard option

Chapter 6.13.6.1
‘Switchboard option’ on page 102 or passive dehu-
midication option

Chapter 6.13.6.2 ‘Passive
dehumidication option’ on page 104.
The control contact must be activated in the device
settings

Chapter 6.13.6 ‘Control contact (option)’
on page 101.

Hettich HettCube 200 Specifications

General

Brand	Hettich
Model	HettCube 200
Category	Laboratory Equipment
Language	English