Hirschmann HiSecOS EAGLE30 - Page 171

Network Security > DPI > OPC Enforcer
Network Security
RM GUI HiSecOS EAGLE20/30
Release 3.0 09/2015
171
 Buttons
Button Meaning
Set Transfers the changes to the volatile memory (
RAM ) of the device and
applies them to the device. To save the changes in the non-volatile
memory, proceed as follows:
 Open the
Basic Settings > Load/Save dialog.
 In the table, highlight the desired configuration profile.
 If in the "Selected" column the checkbox is
unmarked , click the
"Select" button.
 Click the "Save" button.
Reload Updates the fields with the values that are saved in the volatile memory
(
RAM ) of the device.
Create Open the "Create" dialog and add a new entry to the table.
 In the "Index" field, you specify the number of the rule.
Possible values:
–
1..32
When you click the "Ok" button, the device creates the new table entry
and assigns the number specified in the "Index" field to the entry.
Commit Changes The device applies the specified rules to the data stream.
Remove Removes the highlighted rule marked from the table.
To save the changes in the non-volatile memory, proceed as follows:
 Open the
Basic Settings > Load/Save dialog.
 In the table, highlight the desired configuration profile.
 If in the "Selected" column the checkbox is
unmarked , click the
"Select" button.
 Click the "Save" button.
If you mark the "Profile active" checkbox for the rule, the device stops you
from removing the rule.
Help Opens the online help.