Routing > L3-Redundancy > VRRP > Configuration
Routing
366
RM GUI HiSecOS EAGLE20/30
Release
3.0
09/2015
8.25.1 Wizard
The "VRRP Configuration" dialog assists you with creating a table entry. The
following list identifies the prerequisites for creating a VRRP instance:
network routing is functioning correctly
set the IP addresses on the interfaces used in the VRRP instance
Create or Select Entry
Create Opens the "Create" dialog to add a new entry to the table.
In the "Port" field, you specify the router interface.
In the "VRID" field, you specify the Virtual Route Identifier (VRID).
Remove Removes the highlighted table entry.
Wizard Opens the wizard that helps you configure a VRRP instance.
Help Opens the online help.
Parameters Meaning
Port Displays the port number to which the table entry relates.
VRID Displays the Virtual Router IDentifier.
IP Address Displays the primary IP address of the port.
You specify this address in the
Routing > Interfaces > Configuration
dialog.
Netmask Displays the netmask of primary IP address.
You specify this subnet mask in the
Routing > Interfaces >
Configuration dialog.
Button Meaning
To Next Page
Loading...