Hirschmann HiSecOS EAGLE30 - Global

Diagnostics > Status Configuration > Signal Contact > Signal Contact 1
Diagnostics
436
RM GUI HiSecOS EAGLE20/30
Release 3.0 09/2015
9.5.1 Global
 Configuration
With the
Manual Setting mode, you control the signal contact remotely.
This is useful in the following situations, for example:
 Simulating an error during SPS error monitoring.
 Remote control of a device via SNMP, such as switching on a camera.
Parameters Meaning
Mode Specifies which events the device monitors via the signal contact.
Possible values:
 "Manual Setting"
With this mode, you control the signal contact remotely. Closing or
opening the contact turns on or off remote devices, e.g. a remote
camera.
 "Monitoring Correct Operation" (default setting)
In this mode, you specify the individual device functions to monitor via
the signal contact. The signal contact thus makes remote diagnosis
possible.
 "Device Status"
In this mode, the "Signal Contact Status" frame displays the overall
status of the functions monitored in the
Diagnostics > Status
Configuration > Device Status
dialog.
 "Security Status"
In this mode, the "Signal Contact Status" frame displays the overall
status of the functions monitored in the
Diagnostics > Status
Configuration > Security Status
dialog.
 "Device Status"/"Security Status"
In this mode, the "Signal Contact Status" frame displays the overall
status of the functions monitored in the
Diagnostics > Status
Configuration > Device Status
dialog and in the Diagnostics >
Status Configuration > Security Status dialog.
Note: To display the current operating status of the signal contact after
changing the configuration mode, first click "Set" then "Reload".
Contact Displays the status of the signal contact.
Possible values:
 "Opened"
An event has occurred that triggers the signal contact. The signal
contact is opened.
 "Closed"
Normal status. The signal contact is closed.