Routing > ARP > Static
Routing
RM GUI HiSecOS EAGLE20/30
Release
3.0
09/2015
295
8.8.1 Wizard
The wizard allows you to add to the ARP table IP/MAC address assignments
that you have specified yourself. This requires that at least one router
interface is set up.
Edit ARP table
In the fields on the right, specify the IP address and the associated
MAC address.
To insert the IP/MAC address assignment in the table on the left, click
the "Add" button.
To insert new IP/MAC address assignments in the table on the left,
repeat the process.
To apply the IP/MAC address assignments and exit the wizard, click
the "Finish" button.
After closing the wizard, specify the router interface ("Port" field) and
enable IP/MAC address assignment ("Active" field).
To save your settings, click the "Set" button.
Buttons
Parameters Meaning
IP Address Specifies the IP address.
Possible values:
Valid IPv4 address
MAC Address Specifies the MAC address.
Possible values:
Valid MAC address
Button Meaning
Add Adds the values entered in the fields "IP Address" and "MAC Address" to
the list for other addresses. The device uses the IP addresses from this
list for multinetting.
Remove Removes the highlighted entry from the table on the left.
Back Displays the previous page again. Changes are lost.
Next Saves the changes and opens the next page.
To Next Page
Loading...