Basic Settings > Network
Basic Settings
36
RM GUI HiSecOS EAGLE20/30
Release
3.0
09/2015
Basic Settings > Network
1.2 Network
This dialog allows you to specify the IP, VLAN and HiDiscovery settings
required for the access to the device management through the network.
Management Interface
This frame allows you to specify the following settings:
VLAN in which the management can be accessed
Parameters Meaning
IP Address
Assignment
Specifies the source from which the device receives its IP parameters
after starting:
Possible values:
"Local"
The device uses the IP parameters from the internal memory.
You specify the settings for this in the "IP Parameter" frame.
VLAN ID Specifies the VLAN in which the device management is accessible
through the network. You access the device management through ports
that are members of this VLAN.
Possible values:
1..4042
(default setting:
1
)
The prerequisite is that the VLAN is already configured, see the
Switching > VLAN > Configuration
dialog.
Assign a VLAN ID that is not assigned to any routing interface.
When you click the "Set" button after changing the value, the "Information"
dialog opens. Select the desired port, over which you connect to the
device in the future. After clicking the "Ok" button, the device assigns the
new management VLAN settings to the port.
– After that the port is a member of the VLAN and transmits the data
packets without a VLAN tag (untagged). See the
Switching > VLAN >
Configuration dialog.
– The device assigns the port VLAN ID of the management VLAN to the
port. See the
Switching > VLAN > Port
dialog.
After a short time the device is reachable over the new port in the new
management VLAN.
MAC Address Displays the MAC address of the device. The device management is
accessible via the network using the MAC address.
To Next Page
Loading...