Basic Settings > Network
Basic Settings
RM GUI HiSecOS EAGLE20/30
Release
3.0
09/2015
37
HiDiscovery Protocol v1/v2
This frame allows you to specify settings for the access to the device
using the HiDiscovery protocol.
On a PC, the HiDiscovery software displays the Hirschmann devices that
can be accessed in the network on which the HiDiscovery function is
enabled. You can access these devices even if they have invalid or no IP
parameters assigned. The HiDiscovery software allows you to assign or
change the IP parameters in the device.
Note: With the HiDiscovery software you access the device through
device ports that are members of the same VLAN as the device
management exclusively. You specify which VLAN a certain device port
is assigned to in the
Switching > VLAN > Configuration
dialog.
Parameters Meaning
Operation Enables/disables the HiDiscovery function on the device.
Possible values:
"On" (default setting)
HiDiscovery is enabled.
You can use the HiDiscovery software to access the device from your
PC.
"Off"
HiDiscovery is disabled.
Access Enables/disables the write access to the device using HiDiscovery.
Possible values:
readWrite
(default setting)
The HiDiscovery software is given write access to the device.
With this setting you can change the IP parameters in the device.
readOnly
The HiDiscovery software is given read-only access to the device.
With this setting you can view the IP parameters in the device.
Recommendation: Change the setting to
readOnly
exclusively after
putting the device into operation.
Signal Activates/deactivates the flashing of the port LEDs as does the function of
the same name in the HiDiscovery software. The function allows you to
identify the device in the field.
Possible values:
unmarked
(default setting)
The flashing of the port LEDs is inactive.
marked
The flashing of the port LEDs is active.
The port LEDs flash until you disable the function again.
To Next Page
Loading...