Routing > NAT > Double NAT > Overview
Routing
RM GUI HiSecOS EAGLE20/30
Release
3.0
09/2015
415
Routing > NAT > Double NAT > Overview
8.43 Double NAT Overview
In this dialog you will find an overview of which NAT rule is assigned to which
router interface.
You create and edit the NAT rules in the
Routing > NAT > Double NAT >
Rule.
You assign the router interfaces to the corresponding NAT rule in the
Routing > NAT > Double NAT > Mapping
dialog.
Table
Parameters Meaning
Port Displays the number of the router interface on which the device applies the
NAT rule.
Rule Index Displays the sequential number of the NAT rule, see the "Index" in the
Routing > NAT > Double NAT > Rule
dialog.
Rule Name Displays the name of the NAT rule, see the "Rule Name" field in the
Routing > NAT > Double NAT > Rule
dialog.
Local Internal IP
Address
Displays the actual IP address for the device placed in the first network.
Local External IP
Address
Displays the virtual IP address in the second network for the device placed
in the first network.
Remote Internal IP
Address
Displays the actual IP address for the device placed in the second
network.
Remote External IP
Address
Displays the virtual IP address in the first network for the device placed in
the second network.
Trap Displays whether the device sends an SNTP trap when it applies the NAT
rule to a data packet.
Possible values:
marked
The device sends a SNMP trap.
unmarked
The device does not send a SNMP trap.
The prerequisite for sending SNMP traps is that you enable the function in
the
Diagnostics > Status Configuration > Alarms (Traps)
dialog and
specify at least 1 SNMP manager.
To Next Page
Loading...