Routing > ARP > Global
Routing
RM GUI HiSecOS EAGLE20/30
Release
3.0
09/2015
289
Routing > ARP > Global
8.6 ARP Global
This dialog gives you the option to set the ARP parameters and view
statistical values .
Configuration
Information
Parameters Meaning
Aging Time [s] Specifies the average time in seconds, after which the device removes an
entry from the ARP table. The device actually removes an entry after a
randomly determined time in the range (0.5 to 1.5 )× of the value specified
here.
If there is data exchange with the associated device within this time period,
then the time measuring begins from the start again.
Possible values:
15..21600
(default setting:
1200
)
Response Time [s] Specifies the time in seconds, that the device waits for a response before
the query is seen as a failure.
Possible values:
1..10
(default setting:
1
)
Retries Specifies how often the device repeats a failed query before it discards the
query to this address.
Possible values:
0..10
(default setting:
4
)
Parameters Meaning
Total entry current
count
Displays the number of entries that the ARP table contains at the moment.
This includes:
Addresses of the devices which are connected to the router interfaces,
see the
Routing > ARP > Current
dialog.
Addresses of the devices which are connected to the device
management, see the
Diagnostics > System > ARP Table
dialog.
Max. Number of
entries
Displays how many entries the ARP table can contain at a maximum.
To Next Page
Loading...