Network Security > Packet Filter > FLM
Network Security
RM GUI HiSecOS EAGLE20/30
Release
3.0
09/2015
139
4.4.2 Rules
This tab displays the type of data that is traversing the selected ports.
It allows you to create rules to manage the data stream traversing the device.
Using the data displayed in the "Learned Entries" frame you can accept or
reject data as required.
The tab is active after the device forwards 1 data packet.
Learned Entries
Parameters Meaning
Source Address Displays the source address of the packets.
Destination
Address
Displays the destination address of the packet.
Protocol Displays the IP protocol, based on RFC 791, for protocol filtering.
Destination Port Displays the destination port of the packet.
Ingress Interface Displays the interface that received the packet.
Egress Interface Displays the interface that sent the packet.
First Occurrence Displays the first time that the device detected the packet.
Ingress Interfaces Activates/deactivates a display filter allowing you to display only the
connections on a particular ingress interface.
Possible values:
marked
(default setting)
The "Firewall Learning Mode" function on the ports is active.
unmarked
The "Firewall Learning Mode" function on the ports is inactive.
Hide Connections
matching the
learned Rules
Actives/deactivates hiding the entries that match the rules in the
"Packetfilter Rules" table.
Possible values:
marked
(default setting)
Hiding matching rules is active.
unmarked
Hiding matching rules is inactive.
Connections
covered by Rule
Set:
Displays the number of connections that match the rules set in the table
below.
Connections
covered by
Selection:
Displays the number of connections that match the selections in the table
below.
To Next Page
Loading...