Hirschmann HiSecOS EAGLE30 - ACL Assignment

Network Security > ACL > Assignment
Network Security
200
RM GUI HiSecOS EAGLE20/30
Release 3.0 09/2015
Network Security > ACL > Assignment
4.20 ACL Assignment
This dialog allows you to assign one or more Access Control Lists to the ports
and VLANs of the device. By assigning a priority you specify the processing
sequence, provided you assign one or more Access Control Lists to a port or
VLAN.
The device applies rules successively, namely in the sequence specified by
the rule index. You specify the priority of a group in the "Priority" column. The
lower the number, the higher the priority. In this process, the device applies
the rules with a high priority before the rules with a low priority.
The assignment of Access Control Lists to ports and VLANs results in the
following different types of ACL:
 Port-based IPv4-ACLs
 Port-based MAC ACLs
 VLAN-based IPv4 ACLs
 VLAN-based MAC ACLs
Note: Before you enable the function, verify that at least one active entry in
the table allows you access. Otherwise, the connection to the device
terminates when you change the settings. To access the management
functions is possible solely using CLI through the V.24 interface of the device.