Hirschmann HiSecOS EAGLE30 - Page 365

Routing > L3-Redundancy > VRRP > Configuration
Routing
RM GUI HiSecOS EAGLE20/30
Release 3.0 09/2015
365
– "Advertisement Interval [s]"
– "Ping Answer"
– Select the "VRRP Master Candidate" IP address from the drop-
down list.
 To transfer the settings to the VRRP router interface table, click the
"Finish" button.
or
 To assign multinetting and a virtual IPv4 addresses to the virtual
router, click the "Next" button.
 To transfer the settings to the VRRP router interface table, click the
"Finish" button.
 To enable the function, select in the "Operation" frame the "On" radio
button. Then click the "Set" button.
 Editing an existing VRRP router instance
 In the
Routing > L3-Redundancy > VRRP > VRRP Configuration
dialog, highlight a row in the table and click the "Wizard" button to edit
it.
 As an alternative, double-click a field in the table and edit the entry
directly. Or right-click a field and select a value.
 Deleting a VRRP router instance
 In the
Routing > L3-Redundancy > VRRP > VRRP Configuration
dialog, highlight a row and click the "Remove" button.
 Buttons
Button Meaning
Set Transfers the changes to the volatile memory (
RAM ) of the device and
applies them to the device. To save the changes in the non-volatile
memory, proceed as follows:
 Open the
Basic Settings > Load/Save dialog.
 In the table, highlight the desired configuration profile.
 If in the "Selected" column the checkbox is
unmarked , click the
"Select" button.
 Click the "Save" button.
Reload Updates the fields with the values that are saved in the volatile memory
(
RAM ) of the device.