Network Security > RADIUS > Authentication Server
Network Security
176
RM GUI HiSecOS EAGLE20/30
Release
3.0
09/2015
Buttons
Primary Server Specifies the authentication server as primary or secondary.
Possible values:
marked
The server is specified as the primary authentication server. The
device sends the login data for authenticating the users to this
authentication server.
If you activate multiple servers, the device specifies the last server
activated as the primary authentication server.
unmarked
(default setting)
The server is the secondary authentication server. The device sends
the login data to the secondary authentication server if it does not
receive a response from the primary authentication server.
Active Activates/deactivates the connection to the server.
The device uses the server, if you specify in the
Device Security >
Authentication List dialog the value
radius
in one of the rows "Policy 1" to
"Policy 5".
Possible values:
marked
(default setting)
The connection is active. The device sends the login data for
authenticating the users to this server if the preconditions named
above are fulfilled.
unmarked
The connection is inactive. The device does not send any login data
to this server.
Button Meaning
Set Transfers the changes to the volatile memory (
RAM
) of the device and
applies them to the device. To save the changes in the non-volatile
memory, proceed as follows:
Open the
Basic Settings > Load/Save
dialog.
In the table, highlight the desired configuration profile.
If in the "Selected" column the checkbox is
unmarked
, click the
"Select" button.
Click the "Save" button.
Reload Updates the fields with the values that are saved in the volatile memory
(
RAM
) of the device.
Create Opens the "Create" dialog to add a new entry to the table.
In the "Address" field, you specify the IP address of the server.
Remove Removes the highlighted table entry.
Help Opens the online help.
Parameters Meaning
To Next Page
Loading...