Switching > Rate Limiter
Switching
RM GUI HiSecOS EAGLE20/30
Release
3.0
09/2015
247
Broadcast
Threshold
Specifies the threshold value for received broadcasts on this port.
Possible values:
0..14880000
(default setting:
0
)
The value
0
deactivates the rate limiter function on this port.
Enter a percentage from 0 through 100 if you select in the
"Threshold Unit" column the value "percent".
Enter an absolute value for the data rate if you select in the
"Threshold Unit" column the value "pps".
Multicast Mode Activates/deactivates the rate limiter function for received multicast data
packets.
Possible values:
unmarked
(default setting)
marked
If the threshold value is exceeded, the device discards the excess
multicast data packets on this port.
Multicast Threshold Specifies the threshold value for received multicasts on this port.
Possible values:
0..14880000
(default setting:
0
)
The value
0
deactivates the rate limiter function on this port.
Enter a percentage from 0 through 100 if you select in the
"Threshold Unit" column the value "percent".
Enter an absolute value for the data rate if you select in the
"Threshold Unit" column the value "pps".
Unknown Unicast
Mode
Activates/deactivates the rate limiter function for received unicast data
packets with an unknown destination address.
Possible values:
unmarked
(default setting)
marked
If the threshold value is exceeded, the device discards the excess unicast
data packets on this port.
Unicast Threshold Specifies the threshold value for received unicasts with an unknown
destination address on this port.
Possible values:
0..14880000
(default setting:
0
)
The value
0
deactivates the rate limiter function on this port.
Enter a percentage from 0 through 100 if you select in the
"Threshold Unit" column the value "percent".
Enter an absolute value for the data rate if you select in the
"Threshold Unit" column the value "pps".
Parameters Meaning
To Next Page
Loading...