Routing > OSPF > Global
Routing
300
RM GUI HiSecOS EAGLE20/30
Release
3.0
09/2015
Configuration
Parameters Meaning
Router ID Specifies the unique identifier for the router in the Autonomous System
(AS). Ideally, you use the IP address of a router interface on the device.
Possible values:
IP address of an interface (default setting:
0.0.0.0
)
When left unspecified, OSPF automatically selects an IP address from
the router interfaces
External LSDB Limit Specifies the maximum number of entries, non-default AS-external-LSAs,
that the device saves in the link state database. When this limit is reached
then the router enters the overflow state.
Possible values:
-1
(default setting)
The router continues to save entries until the memory is full.
0..2147483647
The device saves up to the specified number of entries.
Specify the same value in the routers on the OSPF backbone and in
any regular OSPF area.
External LSA Count Displays the current number of entries, non-default AS-external-LSAs,
that the device currently holds in the link state database.
Autocost Reference
Bandwidth
Specifies a reference for router interface bandwidth calculations, in Mbps.
You use this value for metric calculations.
Possible values:
1..4294967
(default setting:
100
)
Maximum Paths Specifies the maximum number of ECMP routes that OSPF adds to the
routing table when multiple routes exist for a subnet with same path costs,
but different next hops.
Possible values:
1..4
(default setting:
4
)
To Next Page
Loading...